Knit a beanie for beginners: an easy ribbed hat in three sizes
A ribbed-brim beanie knit in the round, sized from a standard head chart, with cast-on counts and crown decreases that add up at every step.
Quick answer
Knit this beanie in the round with worsted-weight (category 4) yarn on a 16 in US 8 (5 mm) circular needle. At 18 stitches per 4 in, cast on 80, 88 or 96 stitches for heads of about 20 – 21, 21 – 23 or 22 – 24 in. Work 2½ in of k2, p2 ribbing, knit every round until the hat reaches the length for your size, then decrease in eight sections down to 8 stitches and draw the top closed. You need about 200 yd of yarn for the two smaller sizes and around 250 yd for the largest.
- Time 6 – 10 hours for a first hat (estimate)
- Difficulty Advanced beginner: knit, purl, knit two together
- Cost $8 – $30 for yarn, plus about $10 – $20 for needles if you have none
- Makes One ribbed-brim beanie in three adult and teen sizes
A handmade beanie is the natural next project after a garter-stitch scarf. It teaches knitting in the round and one simple decrease, and it gets worn every winter day.
Sizing: measure the head, then subtract
A knitted hat should be smaller than the head it fits so it stays on: this is called negative ease. Knit Picks' hat size charts suggest about 2 in of negative ease for a hat's circumference. Use the Craft Yarn Council's standard head circumference chart if you cannot measure the recipient: about 20 – 22 in for tweens, 21 – 23 in for adult women and 22 – 24 in for adult men. To measure, wrap a tape around the head just above the eyebrows and ears.
| Size | Head circumference | Cast on | Finished hat (unstretched) | Length before crown |
|---|---|---|---|---|
| S (teen, small adult) | 20 – 21 in (51 – 53 cm) | 80 sts | About 17¾ in (45 cm) | 7 in (18 cm) |
| M (most women) | 21 – 23 in (53 – 58.5 cm) | 88 sts | About 19½ in (50 cm) | 7½ in (19 cm) |
| L (most men) | 22 – 24 in (56 – 61 cm) | 96 sts | About 21¼ in (54 cm) | 8 in (20 cm) |
Why these numbers work: at 18 stitches per 4 in (4½ stitches per inch), 88 stitches give about 19½ in. Every cast-on is a multiple of 4 for k2, p2 ribbing and a multiple of 8 for the eight-section crown. The finished height comes out at roughly 9½, 10 and 11 in respectively, a snug beanie that covers the ears.
Materials
- Worsted-weight (category 4) yarn: about 200 yd (183 m) for S or M, about 250 yd (229 m) for L. One 200 – 220 yd skein covers S and M; buy two for L or for a fold-up brim
- US 8 (5 mm) circular needle, 16 in (40 cm) long
- US 8 (5 mm) double-pointed needles (set of 4 or 5), or a 32 in (80 cm) circular for the magic-loop method, for the crown
- One stitch marker
- Tapestry (yarn) needle, scissors, tape measure
- Optional: faux-fur or yarn pom-pom

The Craft Yarn Council lists a gauge of 16 – 20 stitches per 4 in and needles of US 7 – 9 (4.5 – 5.5 mm) for category 4 yarn, so 18 stitches on a US 8 is right in the middle. Pick a smooth, light-colored yarn so you can see your stitches. The yardage figures are estimates for this gauge, in line with Knit Picks' published ranges of 120 – 200 yd for a woman's hat and 200 – 255 yd for a man's (at 5 stitches per inch).
How to knit the hat
Check your gauge
Cast on 24 stitches and knit a 4 to 5 in square in stockinette stitch (knit one row, purl one row). Measure across the middle: you want 18 stitches in 4 in. More stitches per 4 in than that means your hat will be small, so go up a needle size; fewer means go down a size.
Cast on and join in the round
Using the long-tail cast-on, cast on 80 (88, 96) stitches onto the 16 in circular needle. Check that the cast-on edge is not twisted around the needle. Place the marker on the right needle to show the beginning of the round, and knit the first stitch from the left needle snugly to join.
Knit the ribbed brim
Every round: *knit 2, purl 2*, repeat to the marker. Move the yarn between the needles to the front before each purl and to the back before each knit. Because the stitch count is a multiple of 4, each round ends with purl 2 and the ribs line up. Continue until the brim measures 2½ in (6.5 cm). For a fold-up cuff, work 5 in (13 cm) of ribbing instead.
Knit the body
Knit every round. Working in the round, this creates smooth stockinette with no purling at all. Continue until the hat measures 7 (7½, 8) in, or 18 (19, 20) cm, from the cast-on edge. If you made a fold-up cuff, add 2½ in to these lengths.
Decrease the crown
"K2tog" means knit two stitches together as one. Start at the round for your size: L at round 1, M at round 2, S at round 3. Each instruction in asterisks is worked 8 times around, and "knit 1 round" means one plain round with no decreases. Switch to double-pointed needles or magic loop when the stitches no longer reach comfortably around the 16 in needle.
- Round 1 (L starts here, 96 sts): *knit 10, k2tog* = 88 stitches; knit 1 round
- Round 2 (M starts here, 88 sts): *knit 9, k2tog* = 80; knit 1 round
- Round 3 (S starts here, 80 sts): *knit 8, k2tog* = 72; knit 1 round
- Round 4: *knit 7, k2tog* = 64; knit 1 round
- Round 5: *knit 6, k2tog* = 56; knit 1 round
- Round 6: *knit 5, k2tog* = 48; knit 1 round
- Round 7: *knit 4, k2tog* = 40; from here on, no plain rounds
- Round 8: *knit 3, k2tog* = 32
- Round 9: *knit 2, k2tog* = 24
- Round 10: *knit 1, k2tog* = 16
- Round 11: *k2tog* = 8 stitches
Close the top
Cut the yarn, leaving an 8 in (20 cm) tail. Thread it onto the tapestry needle and pass it through the 8 remaining stitches, slipping them off the needles. Pull firmly to close the hole, push the needle to the inside, and secure with a couple of small stitches.
Weave in ends and block
Weave both tails into the wrong side for about 2 in (5 cm), changing direction once, then trim. Wash or steam the hat according to the yarn label and let it dry flat or over a balloon about the size of a head; this evens out the stitches. If you add a pom-pom, sew it on through the crown with several passes of yarn.
Tip: Count after every decrease round. Each round should leave 8 fewer stitches than the one before; if not, the missed k2tog is almost always next to the marker.
Safety and care notes
- For babies and toddlers, skip pom-poms, buttons and other parts that could come off; a knitted brim is all a small hat needs. Never add ties or cords that could wrap around a child's neck.
- Check the yarn label for washing: superwash wool and most acrylics can go in the machine, while regular wool should be hand washed in cool water and dried flat to avoid felting and shrinking.
How to package it as a gift
Fold the brim up, roll the hat, and set it in a small box with tissue, or tuck it inside a coffee mug with a packet of cocoa. Attach a card with the fiber content and care instructions, and keep a little leftover yarn for repairs. A matching knitted headband made from the leftovers is a nice second gift for someone else in the family. More project ideas are in our knit and crochet hub, and if the hat is for a knitter, browse our gifts for knitters.
Frequently asked questions
How many stitches do I cast on for an adult hat?
Multiply your stitch gauge per inch by the head circumference minus about 2 in. At 4½ stitches per inch and a 22 in head, that is about 90; rounding to 88 keeps it divisible by 4 for ribbing and by 8 for the crown.
How much yarn does a beanie take?
For this worsted-weight pattern, roughly 200 yd for small and medium and about 250 yd for large, or more with a folded brim. These are estimates; buy an extra skein from the same dye lot if you can.
Can I knit it flat on straight needles?
Yes. Cast on 2 extra stitches (82, 90 or 98) and treat the first and last stitch as seam stitches: knit them on right-side rows and purl them on wrong-side rows. Between them, work *k2, p2* on right-side rows; on wrong-side rows, knit the knits and purl the purls as they face you. Knit right-side rows and purl wrong-side rows for the body, work each crown decrease on a right-side row with a purl row after it, then sew the back seam with mattress stitch.
Sources
- Craft Yarn Council — Head Circumference Chart. craftyarncouncil.com
- Craft Yarn Council — Standard Yarn Weight System. craftyarncouncil.com
- Knit Picks — Hat Size Charts. knitpicks.com
Image credits. Top image: Beanie by ChesPal (Debra Heaphy), CC BY-SA 3.0, via Wikimedia Commons · In-article image: Circular knitting needles by Pschemp, CC BY-SA 3.0, via Wikimedia Commons
Spotted something out of date or a gift that's no longer available? Tell our editors — we review every correction.